Freelander Steering Pump Repair - K18
STEERING
57-14
REPAIRS
Pump - steering - K1.8
$% 57.20.14
Remove
1. Disconnect battery earth lead.
2. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
3. Loosen PAS pump pulley bolts.
4. Remove PAS pump drive belt.
STEERING, REPAIRS, Drive belt -
5. Position container to collect PAS fluid spillage.
6. Release clip and disconnect fluid inlet hose
from PAS pump.
CAUTION: Always fit plugs to open
connections to prevent contamination.
7. Loosen union securing fluid outlet pipe, release
outlet pipe remove and discard 'O' ring.
8. Remove 3 bolts securing PAS pump pulley to
PAS pump and remove pulley.
9. Remove 5 bolts securing PAS pump to
mounting bracket.
10. Remove PAS pump.
Refit
1. Position PAS pump and align to mounting
bracket.
2. Fit bolts securing PAS pump to mounting
bracket and tighten to 25 Nm (18 lbf.ft).
3. Fit PAS pump pulley and align bolts holes.
Ensure FRONT mark is facing outwards. Fit
bolts finger tight.
4. Remove plug from fluid outlet hose.
5. Clean PAS pump and pipe union.
6. Using a new 'O' ring, align outlet pipe and
tighten union to 20 Nm (15 lbf.ft).
7. Clean elbow on PAS pump.
8. Remove plug from fluid inlet hose, fit new clip
and connect hose to PAS pump.
9. Remove container.
10. Clean pulley 'V's and tensioner pulley running
surface.
11. Fit PAS pump drive belt.
STEERING, REPAIRS, Drive belt -
12. Tighten PAS pump pulley bolts to 10 Nm (7.5
lbf.ft).
13. Connect battery earth lead.
14. Bleed PAS system.
assisted steering (PAS) system - bleed.
M57 1069
M57 1070