Airbag and Pre-tensioner Deployment

Airbag and Pre-tensioner Deployment

WARNING: Only personnel who have undergone the appropriate training should undertake deployment of airbag and pre-tensioner modules.

WARNING: A deployed airbag is very hot, DO NOT return to a deployed airbag module until at least 30 minutes have elapsed since deployment.

WARNING: Deployment procedures and precautions as detailed in this service manual should be strictly adhered to. The following precautions must be complied with: • Only use deployment equipment approved for the intended purpose. • Before beginning deployment procedure, ensure deployment tool functions properly by performing the self test procedure detailed in SRS section of this manual. • Deployment of airbag / pre-tensioner modules should be performed in a well ventilated area which has been designated for the purpose. • Ensure airbag / pre-tensioner modules are not damaged or ruptured before attempting to deploy. • Notify the relevant authorities of intention to deploy airbag and pre-tensioner units. • When deploying airbag pre-tensioner units, ensure that all personnel are at least 15 metres away from the deployment zone. • Ensure deployment tool is connected correctly, in compliance with the instructions detailed in the SRS section of this manual. In particular, ensure deployment tool is NOT connected to battery supply before connecting to airbag module connector. • When deploying seat belt pre-tensioners, ensure pre-tensioner unit is secured correctly to seat. • When removing deployed airbag modules and pre-tensioner units, wear protective clothing. Use gloves and seal deployed units in a plastic bag. • Following deployment of any component of the SRS system within the vehicle, all SRS components must be replaced. DO NOT re-use or salvage any parts of the SRS system. • Do not lean over airbag module when connecting deployment equipment.

WARNING: If a vehicle is to be scrapped, undeployed airbag modules and pre-tensioner units must be manually deployed. In this case airbags can be deployed in the vehicle; before deployment, ensure the airbag module is secure within its correct mounting position.

CAUTION: Deployment of the driver side airbag in the vehicle may damage the steering wheel; if the vehicle is not being scrapped, deploy the module outside of the vehicle.