L322 Range Rover Service Procedures
DRIVESHAFTS
47-10
REPAIRS
3. Slide gaiter along drive shaft to gain access to
inner joint.
4. Remove excess grease from joint and inner
member.
5. Reference mark drive shaft and joint for
assembly purposes.
6. Remove joint and inner member from drive
shaft.
7. Remove gaiter from shaft and discard.
Refit
1. Clean drive shaft, joint and inner member.
2. Fit new gaiter to drive shaft.
3. Ensuring reference marks are aligned, fit joint
and inner member to drive shaft.
4. Apply grease from the sachet to the joint.
5. Position gaiter to joint and secure to joint and
shaft with new clips.
6. Fit drive shaft.
Seal - drive shaft - front - RH
$% 47.10.40
Remove
1. Raise front of vehicle.
Warning: do not work on or under a vehicle
supported only by a jack. Always support
the vehicle on safety stands.
2. Remove front road wheels.
3. Remove RH brake disc.
4. Release abs sensor lead from clip.
5. Release sensor lead from damper, remove
allen screw and release ABS sensor from hub.
M47 0412