Front Shock (60.30.02.45) (page 4 of 4)

8 . 

  Install the nylon retaining pin. 

9 . 

  Install a new nut and tighten to 98 Nm (72 lb.ft). 

10 . 

  Check the assembly for leaks. 

Inflate the module to 4 bar and check for pressure loss.

If a leak is suspected, immerse the spring and shock absorber assembly in a tank of 
water to locate the source of the leak.

11 . 

  Remove the special tool. 

12 . 

Install the shock absorber and spring assembly. For additional information, refer to 

Front Shock 

Absorber and Air Spring Assembly (60.21.01.99)

 (Section 204-05)