LR3/Disco 3
Installation
5 .
Remove the Voss connector from the air line.
Remove and discard the collet and the union.
1 .
CAUTION: Make sure the new Voss connector is installed and fully tightened with the
alignment plug installed.
Install a new Voss connector to the air reservoir.
Tighten the new Voss connector to 5 Nm (4 lb.ft).
2 .
Install the air suspension reservoir.
Locate the air reservoir to the chassis brackets, fit the bolts and tighten to 23 Nm (17 lb.ft).
Fully seat the air line into the Voss connector.
Pull on the air line to make sure it is fully installed into the Voss connecter.
3 .
Using T4, pressurize the air suspension. For additional information, refer to
Air Suspension System
Depressurize and Pressurize (60.50.38)
(Section 204-05 Vehicle Dynamic Suspension)