LR3/Disco 3
Camshaft RH (12.13.03)
Removal
NOTE :
Installation
Published : Jun 21, 2004
Removal of the LH camshaft is similar to this procedure.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Refer to valve timing check and adjust. For additional information, refer to (Section 303-01)
3 .
Remove the camshaft sprocket bolt.
Position the sprocket and chain aside.
4 .
NOTE :
Remove the camshaft bearing caps evenly and in stages.
NOTE :
Note the fitted position.
Remove the camshaft bearing caps.
Remove the 8 bolts.
Collect the camshaft oil supply line.
5 .
Remove the camshaft.
1 .
Install the camshaft.
Clean the component mating faces.
Lubricate the components with clean engine oil.
2 .
NOTE :
Note the fitted position.
Install the camshaft bearing caps.
Clean the component mating faces.