LR3/Disco 3 - Engine- 40L - In Vehicle Repair - LH Exhaust Manifold (Page 847)
Installation
All vehicles
1 .
NOTE :
The exhaust manifold gasket connecting links must be positioned to the lower edge of the manifold.
Install the exhaust manifold.
Install a new gasket.
Clean the component mating faces.
Tighten the nuts evenly in the sequence shown to 25 Nm (18 lb.ft).
2 .
Install the dipstick tube.
Clean the component mating faces.
Install a new O-ring seal.
Lubricate the seal with clean engine oil.
Tighten the bolt to 10 Nm (7 lb.ft).
Install the dipstick.
3 .
Connect the HT electrical connectors.
4 .
Install the EGR pipe.
Clean the component mating faces.
Initially, finger tighten the nuts.
Finally, tighten the nuts to 40 Nm (30 lb.ft).
5 .