LR3/Disco 3
Install the spacer.
Align the bolt hole with the alignment notch, to the mark previously made on the
crankshaft.
Using the special tool, lock the flexplate.
Tighten the Torx bolts evenly in 2 stages, in the sequence shown.
Tighten the Torx bolts to 15 Nm (11 lb.ft).
Tighten the Torx bolts to 72 Nm (53 lb.ft)
2 .
Install the transmission. For additional information, refer to
Transmission (44.20.01)
(Section 307-01)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)