LR3/Disco 3
10 .
Install the coolant manifold.
Tighten the bolts to 6 Nm (4 lb.ft).
Install the coolant hoses.
Secure with the clips.
11 .
Install the coolant expansion tank hose.
Connect the clip.
12 .
Install the coolant pump pulley.
Tighten the bolts to 10 Nm (7 lb.ft).
13 .
Install the accessory drive belt idler pulley.
Tighten the bolt to 25 Nm (18 lb.ft).
14 .
NOTE :
Care must be taken when installing the plug top coil ground connections. The engine will fail to start
on either or both banks if the ground is poor.
Secure the engine wiring harness clips.
15 .
Install the cooling fan drive belt tensioner.
Tighten the pulley bolt to 25 Nm (18 lb.ft).
Tighten the tensioner bolt to 40 Nm (30 Ib.ft).
16 .
Install the A/C mounting bracket.
17 .
Install the A/C compressor. For additional information, refer to
Air Conditioning (A/C) Compressor
(82.10.20)
(Section 412-03B )
18 .
Install the cooling fan shroud.
19 .
Install the throttle body gasket. For additional information, refer to
Throttle Body Gasket
(Section
303-04)
20 .
Refill and bleed the cooling system. For additional information, refer to
Cooling System Draining,
Filling and Bleeding (26.10.01)
(Section 303-03)
