LR3/Disco 3
Installation
1 .
Install the schraeder valve.
Clean the component mating faces.
Install a new O-ring seal.
Tighten the bolts to 6 Nm (4 lb.ft).
2 .
Clean the components.
3 .
Install the fuel rail.
Install fuel injector O-ring seals.
Lubricate the O-ring seals.
Tighten the bolts to 25 Nm (18 lb.ft).
4 .
Connect the fuel line to the fuel rail.
Clean the component mating faces.
Install the clip.
Tighten the bolt to 6 Nm (4 lb.ft).
5 .
Install the intake manifold. For additional information, refer to
Intake Manifold (30.15.02)
(Section
303-01)
6 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)