LR3/Disco 3
Tighten the Torx screws.
Connect the electrical connector.
13 .
Attach the transmission fluid lines.
Clean the components.
Install the new O-ring seals.
Secure with the clip.
Tighten the bolt to 10 Nm (7 lb.ft).
14 .
Install the fuel pipe heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).
Secure with the clips.
15 .
Install the transmission heat shield bracket.
Tighten the bolts to 10 Nm (7 lb.ft).
16 .
Attach the selector cable.
17 .
Install the transfer case. For additional information, refer to
Transfer Case - 4.0L (41.20.25.99)
(Section 308-07B Transfer Case)
18 .
Adjust the selector cable. For additional information, refer to
Selector Lever Cable Adjustment
(44.30.04)
(Section 307-05A Automatic Transmission/Transaxle External Controls - 4.0L)
19 .
Check and top-up the transmission fluid level. For additional information, refer to
Transmission
Fluid Level Check (44.24.06)
(Section 307-01B Automatic Transmission/Transaxle - 4.4L)
20 .
Install the transmission heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).