LR3/Disco 3
Vehicles with auxiliary climate control
All vehicles
21 .
LH side: Connect the body panel electrical connectors.
1 .
LH side: Secure the A/C lines to the body panel.
Tighten the nut to 10 Nm (7 lb.ft).
1 .
LH side: Connect the adaptive front lighting control module electrical connector.
2 .
LH side: Connect the washer jet hose.
3 .
Passenger side: Connect the transfer case electrical connector.
4 .
Passenger side: Connect the engine wiring harness electrical connector.
5 .
Install the headlamps. For additional information, refer to
Headlamp Assembly (86.40.49)
(Section
417-01)
6 .
Install the fender splash shields. For additional information, refer to
Fender Splash Shield (76.10.48)
(Section 501-02)
7 .
Attach the BJB wiring harness to the bulkhead.
Connect the electrical connectors.
Install the grommet.
8 .
Install the battery ground cable.
Attach the additional ground cable.
Tighten the nut to 25 Nm (18 lb.ft).
9 .
Secure the BJB to the bracket.
Tighten the bolt to 6 Nm (4 lb.ft).
10 .
Connect the heater motor electrical connector.
11 .
Connect the ground cables to the lower A-pillar.
Tighten the nut to 10 Nm (7 lb.ft).
12 .
Install the CJB bracket.
Tighten the nuts to 10 Nm (7 lb.ft).
Secure the clips.
Connect the electrical connectors.
Tighten the bolts to 25 Nm (18 lb.ft).