LR3/Disco 3
7 .
Connect the battery to engine compartment wiring harness electrical connector.
8 .
Connect the A/C pressure transducer electrical connector.
9 .
Connect the brake booster vacuum pump electrical connector.
10 .
Attach the hood wiring harness.
Install the grommet.
Install the cover.
Secure with the clips.
Connect the electrical connectors.
Connect the washer jet hoses.
11 .
Install the hood pad.
Install the clips.
12 .
Install the windshield wiper motor. For additional information, refer to
Windshield Wiper Motor
(84.15.12)
(Section 501-16)
13 .
LH side: Attach the wiring harness.
Install the grommet.
Secure the clips.
14 .
LH side: Connect the brake pad wear sensor electrical connector.
15 .
LH side: Connect the coolant expansion tank level switch electrical connector.
16 .
LH side: Attach the washer reservoir wiring harness.
Connect the washer jet hoses.
Connect the electrical connectors.
17 .
LH side: Attach the engine compartment ground cables.
Secure the clips.
Tighten the nuts to 25 Nm (18 lb.ft).
18 .
LH side: Connect the ABS electrical connector.
19 .
LH side: Attach the air suspension pipes.
Secure the clips.
20 .
LH side: Attach the body panel ground cables.
Tighten the nut to 25 Nm (18 lb.ft).