LR3/Disco 3
Vehicles with auxiliary heating
All vehicles
7 .
Connect the hood switch electrical connector.
8 .
RH side: Secure the wiring harness.
Secure the clips.
9 .
Connect both front impact electrical connectors.
Secure the clips.
10 .
RH side: Attach the air suspension pipe.
11 .
Connect the ambient air temperature sensor electrical connector.
12 .
RH side: Attach the engine compartment ground cables.
Tighten the nuts to 25 Nm (18 lb.ft).
13 .
RH side: Connect the ABS electrical connector.
14 .
RH side: Attach the body panel ground cables.
Tighten the nut to 25 Nm (18 lb.ft).
15 .
RH side: Connect the body panel electrical connectors.
1 .
RH side: Secure the heater pipes to the body panel.
Tighten the nut to 10 Nm (7 lb.ft).
1 .
Driver side: Attach the wiring harness to the bulkhead.
Install the grommet.
2 .
Driver side: Connect the lower A-pillar electrical connectors.
3 .
Install the air suspension control module. For additional information, refer to
Air Suspension Control
Module (60.50.04)
(Section 204-05)
4 .
Connect the ABS module electrical connector.
5 .
Connect the brake fluid reservoir electrical connector.
6 .
Attach the wiring harness to the plenum.
Secure the clips.
Tighten the nuts to 4 Nm (3 lb.ft).