LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Hood Latch Release Cable: Service and Repair
Installation
ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION
HINT
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts.
1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the cable into the engine room.
(b) Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.
(c) Pass the cable front side through the upper radiator support.
(d) Connect the clamps as shown in the illustration.
2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
(a) Install the hood lock lever and connect the hood lock control cable.
(b) Attach the 2 claws.
3. INSTALL HOOD LOCK ASSEMBLY