B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Cruise Control Switch: Service and Repair
Cruise Control Switch Wiring Harness
1. Remove cruise control switches.
2. Disconnect steering wheel wiring harness connector at right side of steering wheel attaching bolt.
3. Remove steering wheel.
4. Disconnect wiring harness terminals from the two horn switches.
5. Remove right horn switch.
6. On back side of steering wheel, remove two screws and back cover.
7. Disconnect wiring harness.
NOTE:
- With steering wheel rim facing down on a bench, route wiring harness around steering wheel upper spokes to switch locations. Route wiring with
black 5-pin air bag sliding contact connector from right cruise control switch through two retaining clips and through two wiring locating ribs
beneath the right horn switch.
1. Route horn switch wires as follows: Wire from the right cruise control switch to the left horn switch and the wire from the left cruise control
switch to the right horn switch.
2. Carefully route wiring between the locator posts and the top inside of the back cover.
8. Install wiring harness in reverse order.
Tightening torque: Horn switch screws 6.5 - 7.5 N.m (6.7 - 7.5 kgf.m, 4.8 - 5.5 ft.lbf).
