B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
7. Use the above procedure to check the piston travel with the newly selected low/reverse band servo piston and rod (if required) to make sure that
the piston travel is 3-5.6 mm (0.120-0.220 inch). Remove the servo gauge and the low/reverse band servo return spring.
-
Grooves are located on low/reverse servo rod.
8. Install the selected reverse band servo piston and rod.
1) Install the reverse band servo piston and rod assembly.
2) Install a new reverse servo separator plate cover gasket.
3) Install the low/reverse band servo cover.
-
Loosely install the reverse servo piston cover bolts.
4) Tighten the servo cover bolts in the sequence shown.
9. Install the (1) oil strainer.
10. Install the (2) bolt.