B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
11. Remove the extension housing and discard extension housing gasket.
12. Clean the extension housing and install new extension housing gasket. Ensure that the parking pawl is correctly installed.
CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
13. Position the extension housing and install screws and stud(s).
14. Position transmission mount on extension housing and install screws.
Tightening torque: 68 - 95 Nm (6.9 - 9.7 kgf-m, 50 - 70 ft. lbs.)
15. Install transmission mount into crossmember and tighten transmission mount nuts.
Tightening torque: 98 - 132 Nm (10 - 13.5 kgf-m, 73 - 97 ft. lbs.