B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
CAUTION: To avoid damage, make sure the wrench does not strike the manual valve inner lever pin.
12. Remove the manual valve inner lever nut.
13. Remove the manual valve inner lever and parking lever actuating rod.
: To maintain initial propeller shaft balance, mark the rear propeller shaft yoke and axle flange so they may be installed in their original position.
14. Mark the rear propeller shaft.
15. Remove the rear propeller shaft.
16. If equipped, remove the transfer case.
NOTE:
^
If damage is found to the parking gear, the transmission must be removed and disassembled.
^
The parking pawl, parking pawl return spring and parking pawl shaft may fall out during removal of the extension housing.
17. Remove the extension housing. Discard the extension housing gasket.
18. Inspect the parking pawl, parking pawl return spring and the parking pawl shaft.
1) Replace if required.
INSTALLATION NOTE
