B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
CAUTION: Make sure the parking lever actuating rod Is correctly seated into the case parking rod guide cup. Verify that the output shaft is locked in
the PARK position.
1. Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
CAUTION: Do not bend the manual valve inner lever pin.
2. Install the manual valve inner lever nut.
3. Install new extension housing gasket and install the extension housing.
4. If equipped, install the transfer case. Refer to 03-16 TRANSFER.
NOTE: Align the drive shaft with the marks made during removal to ensure correct balance.
5. Install the rear propeller shaft.
NOTE:
^
Make sure the tab is in the lock position.
^
Install new O-rings on the transmission case (16 pinch) electrical connector.
6. Install the transmission case (16 pinch) electrical connector.
-
Lubricate the transmission case (16 pinch) electrical connector O-rings with petroleum jelly.
