B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Shifter A/T: Service and Repair
Selector Lever Removal/Installation
SELECTOR LEVER REMOVAL/ INSTALLATION
1. Remove the ignition switch.
2. Remove the upper steering column shroud and the rubber shift lever cover.
3. Remove the selector lever.
1) Disconnect the shift control selector lever harness connector.
2) Remove and discard the selector lever pin.
3) Remove the selector lever.
NOTE: The selector lever pin must be replaced when ever removed.
4. Install in reverse order of removal.