B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
7. Remove the master cylinder reservoir and master cylinder.
-
Rotate the master cylinder 45 degrees clockwise.
8. Clean all clutch master cylinder components.
9. Inspect the clutch master cylinder for:
-
weak spring.
-
damage to any reservoir components.
-
damaged cups.
-
scored piston.
10. Lightly clamp clutch master cylinder reservoir in a vise.
11. Fill clutch master cylinder reservoir to full line.
-
Use DOT 3 brake fluid or equivalent.
12. Place clutch slave cylinder end of tube in a waste container.
NOTE:
^
Make sure the clutch master cylinder reservoir is full during bleeding procedure to prevent air from entering the clutch master cylinder.
^
Bleed the clutch master cylinder until a solid stream of brake fluid exits at the quick connect coupling end of tube.
13. Open the (A) internal mechanism of the male quick connect coupling and fully depress and hold the (B) clutch master cylinder push rod.
