B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
c.
Set boot length to 76 mm (3") by sliding slip yoke in or out. Measure between inner side of clamps as shown.
d.
Bleed air from slip yoke boot using a screwdriver as shown.
20.
Using SST 211-002 or aftermarket equivalent, crimp slip yoke boot clamp at same position as when removed.
DRIVESHAFT INSTALLATION
21.
Align front of drive shaft to mark on transfer case flange. Tighten front flange bolts. Tightening torque: 111 N.m (82 lb-ft).
22.
Align rear of drive shaft to mark on pinion flange. Tighten rear flange bolts. Tightening torque: 112 N.m (83 lb-ft).
23.
Verify repair.
PART(S) INFORMATION
WARRANTY INFORMATION
