Removal note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Camshaft Removal and Installation › Removal note
EngineRemoval note
Removal note
Camshaft pulley
- Hold the camshaft with a wrench.
- Remove the camshaft pulley lock bolt.
- Remove the camshaft pulley.
Camshaft
- Loosen the camshaft cap bolts in two or three steps in the order shown in the figure.
- Remove the camshaft caps.
- Remove the camshaft.
- Remove the camshaft oil seal from the camshaft.
HLA
Caution
- Mark the HLA with a felt pen so that they can be reinstalled in the position from which they were removed.
- Remove the HLA from the cylinder head.
Installation note
HLA
- Apply clean engine oil to the friction surfaces.
- If the HLA are being reused, install them in the position from which they were removed.
- Verify that the HLA move smoothly in their bores.
Camshaft
Note
- The intake camshaft is grooved for the crank angle sensor drive.
- Apply clean engine oil to the camshaft journals and bearings.
- Install the camshaft in position.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.