Camshaft pulley
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Camshaft (B) › Camshaft pulley
EngineCamshaft pulley
Caution
• Do not allow any sealant on the camshaft journal surfaces.
- Apply silicone sealant to the shaded areas shown in the figure.
- Install the camshaft caps according to the cap number and arrow mark.
- Install the camshaft cap bolts and tighten them in two or three steps in the order shown in the figure.
Tightening torque:
11.3—14.2 N·m (1.15—1.45 m·kg, 100—126 in·lb)
- Apply a small amount of clean engine oil to the lip of a new camshaft oil seal.
- Push the oil seal slightly in by hand.
Caution
• The oil seal must be tapped in until it is flush with the edge of the camshaft cap.
- Tap the oil seal in evenly with a suitable pipe and a hammer.
Oil seal outer diameter: 48mm (1.89 in)
Camshaft pulley
- Turn the camshafts until the camshaft dowel pins face straight up.
- Install the camshaft pulleys with the I mark (intake side) or the E mark (exhaust side) straight up.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.