Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Compression › Inspection
EngineInspection
If the engine exhibits low power, poor fuel economy, or poor idle, check the following:
- Ignition system (Refer to page G–17.)
- Compression
- Fuel system (Refer to page F–100.)
INSPECTION
- Check that the battery is fully charged. Recharge it if necessary. (Refer to page G–8.)
- Warm up the engine to the normal operating temperature.
- Turn the engine OFF.
- Remove all spark plugs.
- Disconnect the ignition coil connector.
- Connect a compression gauge to the No.1 spark plug hole.
- Fully depress the accelerator pedal and crank the engine.
- Record the maximum gauge reading.
- Check each cylinder.
Compression:
1,324 kPa (13.5 kg/cm², 192 psi) - 300 rpm
Minimum:
932 kPa (9.5 kg/cm², 135 psi) - 300 rpm
Differential limit between cylinders:
196 kPa (2.0 kg/cm², 28 psi)
- If the compression in one or more cylinders is low, pour a small amount of engine oil into the cylinder and recheck the compression.
(1) If the compression increases, the piston, piston rings, or cylinder wall may be worn.
(2) If the compression stays low, the valve may be stuck or seating improperly.
(3) If the compression in adjacent cylinders stays low, the cylinder head gasket may be defective or the cylinder head distorted. - Connect the ignition coil connector.
- Apply antiseize compound or molybdenum-based lubricant to the spark plug threads.
- Install the spark plugs.
Tightening torque:
15—23 Nm (1.5—2.3 m-kg, 11—17 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.