Crankshaft
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Crankshaft and Bearing Inspection › Crankshaft
EngineCrankshaft
05U0BX-163
CRANKSHAFT
- Check the journals and pins for damage, scoring, and oil hole clogging.
- Set the crankshaft on V-blocks.
- Measure the crankshaft runout at the center journal. Replace the crankshaft if necessary.
Runout: 0.04mm (0.0016 in) max.
05U0BX-164
- Measure each journal diameter in X and Y directions at two points.
Main journal
Diameter: 49.938—49.956mm (1.9661—1.9668 in)
Out-of-round: 0.05mm (0.0020 in) max.
Crankpin journal
Diameter: 44.940—44.956mm (1.7693—1.7699 in)
Out-of-round: 0.05mm (0.0020 in) max.
Caution
- Do not remove the fillet roll area R when grinding.
- If the diameter is less than the minimum, grind the journals to match an undersize bearing.
Undersize bearing:
0.25mm (0.010 in), 0.50mm (0.020 in),
0.75mm (0.030 in)
Main journal diameter undersize
mm (in)
| Bearing size | Journal diameter |
|---|---|
| 0.25 (0.010) undersize | 49.704—49.708 (1.9568—1.9570) |
| 0.50 (0.020) undersize | 49.454—49.458 (1.9470—1.9472) |
| 0.75 (0.030) undersize | 49.204—49.208 (1.9372—1.9373) |
05U0BX-165
05U0BX-166
Crankpin journal diameter undersize
mm (in)
| Bearing size | Journal diameter |
|---|---|
| 0.25 (0.010) undersize | 44.690—44.706 (1.7594—1.7601) |
| 0.50 (0.020) undersize | 44.440—44.456 (1.7496—1.7502) |
| 0.75 (0.030) undersize | 44.190—44.206 (1.7398—1.7404) |
05U0BX-167
BEARING
Main Bearing and Connecting Rod Bearing
- Check the main bearings and the connecting rod bearings for peeling, scoring, and other damage.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.