Preparation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Disassembly › Preparation
EnginePreparation · page 1 of 2
PREPARATION
SST
| 49 E301 060 Brake, ring gear |
For prevention of engine rotation | 49 E301 061 Body (Part of 49 E301 060) |
For prevention of engine rotation |
| 49 E301 062 Collar (Part of 49 E301 060) |
For prevention of engine rotation | 49 0636 100A Arm, valve spring lifter |
For removal and installation of valves |
| 49 B012 006 Pivot, valve spring lifter |
For removal and installation of valves | 49 S120 170 Remover, valve seal |
For removal of valve seals |
| 49 0221 061A Remover & installer, piston pin |
For removal and installation of piston pins | 05U0BX-090 | |
- Code all identical parts (such as piston, piston rings, connecting rods, and valve springs) so that they can be reinstalled in the cylinder from which they were removed.
- Clean the parts with a steam cleaner. Blow off any remaining water with compressed air.
Note
• During disassembly of any part or system, be sure to study its order of assembly. Also, note any deformation, wear, or damage.
05U0BX-091
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.