Procedure (page 2 of 2)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine
EngineProcedure · page 2 of 2
- Install the SST (arms) to the holes as shown in the figure, and loosely tighten the SST (bolts).
- Assemble the SST (bolts and plate) in the specified position.
- Assemble the SST (nuts, hooks, and bolts).
- Install the SST to the respective arms.
Note
- Adjust the SST (bolts) so that less than 20mm (0.79 in) of thread is exposed.
- Make the SST (plate and arms) parallel by adjusting the SST (bolts and nuts).
- Tighten the SST (bolts and nuts) to affix the SST firmly.
- Mount the engine on the SST (engine stand).
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.