Cylinder Head Gasket
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- B Engine › Cylinder Head Gasket
EngineCylinder Head Gasket
Cylinder Head Gasket
- Remove all foreign material from the top of the cylinder block.
- Place the new cylinder head gasket in position.
Cylinder Head
- Install the cylinder head.
- Apply clean engine oil to the bolt threads and seat faces.
- Tighten the cylinder head bolts in two or three steps in the order shown.
Tightening torque:
76—81 N·m (7.7—8.3 m-kg, 56—60 ft-lb)
Thermostat Housing
- Remove all foreign material from the thermostat housing mounting surface.
- Install a new O-ring and the thermostat housing.
Tightening torque:
19—25 N·m (1.9—2.6 m-kg, 14—19 ft-lb)
Seal Plate
- Install the seal plate on the cylinder head.
Tightening torque:
7.8—11 N·m (80—110 cm-kg, 69—95 in-lb)
HLA
- Apply clean engine oil to the friction surfaces.
- If the HLA are being reused, install them in the position from which they were removed.
- Verify that the HLA move smoothly in their bores.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.