Valve and Valve Spring
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Valve Seal › Valve and Valve Spring
EngineValve and Valve Spring
- Assemble the SST so that depth L is as specified.
Depth L: 18.3—18.5mm (0.720—0.728 in)
- Slide the valve seal onto the valve guide.
- Set the SST against the valve seal.
Caution
- Do not use a hammer.
- Press the valve seal on until the SST contacts the cylinder head.
Valve and Valve Spring
- Install the lower spring seat.
- Install the valve.
Caution
- Install the spring with the closer pitch toward the cylinder head.
- Install the valve spring and the upper spring seat.
- Compress the valve spring with the SST, and install the valve keepers.
- Remove the SST.
- Tap the end of the valve stem lightly two or three times with a plastic hammer to verify that the keepers are all fully seated.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.