Accelerator cable
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Installation note (B) › Accelerator cable
EngineAccelerator cable
Installation note
Cylinder head bolt
- Apply clean engine oil to the bolt threads and seat faces.
- Install the cylinder head bolts.
- Tighten the cylinder head bolts in two or three steps in the order shown in the figure.
Tightening torque:
76—81 N·m (7.7—8.3 m-kg, 56—60 ft-lb)
Accelerator cable
- Install the accelerator cable.
- Check the accelerator cable deflection.
If the deflection is not correct, adjust by turning nut A.
Deflection: 1—3mm (0.04—0.12 in)
Steps After Installation
- Fill the radiator with the specified amount and type of engine coolant. (Refer to page E–5.)
- Connect the negative battery cable.
- Start the engine and check as follows:
(1) Engine oil and engine coolant leakage.
(2) Ignition timing, idle speed. (Refer to page B–8.)
(3) Operation of emission control system. - Recheck the engine coolant levels.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.