Piston, piston ring, and piston pin
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Piston, piston ring, and piston pin › Piston, piston ring, and piston pin
EnginePiston, piston ring, and piston pin
PISTON, PISTON RING, AND PISTON PIN
Piston
Caution
• If the piston is replaced, the piston rings must also be replaced.
- Inspect the outer circumferences of all pistons for seizure or scoring. Replace the piston if necessary.
- Measure the outer diameter of each piston at a right angle (90°) to the piston pin, 16.5mm (0.650 in) below the oil ring land lower edge.
Piston diameter
mm (in)
| Piston size | Diameter |
|---|---|
| Standard | 77.954—77.974 (3.0690—3.0698) |
| 0.25 (0.010) oversize | 78.211—78.217 (3.0792—3.0794) |
| 0.50 (0.020) oversize | 78.461—78.467 (3.0890—3.0892) |
- Measure the piston-to-cylinder clearance.
Clearance: 0.039—0.052mm (0.0015—0.0020 in)
Maximum: 0.15mm (0.006 in)
- If the clearance exceeds the maximum, replace the piston or rebore the cylinders to fit oversize pistons.
Piston and Piston Rings
- Measure the piston ring to ring land clearance around the entire circumference using a new piston ring.
Clearance (Top and Second):
0.03—0.07mm (0.0012—0.0028 in)
Maximum: 0.15mm (0.006 in)
- If the clearance exceeds the maximum, replace the piston.
- Inspect the piston rings for damage, abnormal wear, or breakage. Replace the piston rings if necessary.
- Insert the piston ring into the cylinder by hand and use the piston to push it to the bottom of the ring travel.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.