Rear Cover
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Rear Cover and Oil Pump › Rear Cover
EngineRear Cover
Rear Cover
- Apply a small amount of clean engine oil to the lip of a new oil seal.
- Push the oil seal slightly in by hand.
Caution
• The oil seal must be pressed in until it is flush with the edge of the rear cover.
- Press the oil seal in evenly with a suitable pipe.
Oil seal outer diameter: 100mm (3.94 in)
- Apply silicone sealant to the shaded area shown in the figure.
- Install the rear cover.
Tightening torque:
7.8—11 Nm (80—110 cm-kg, 69—95 in-lb)
Oil Pump
- Apply a small amount of clean engine oil to the lip of a new oil seal.
- Push the oil seal slightly in by hand.
Caution
• The oil seal must be pressed in until it is flush with the edge of the oil pump body.
- Press the oil seal in evenly with a suitable pipe.
Oil seal outer diameter: 44mm (1.73 in)
- Install the oil pump and a new gasket.
Tightening torque:
19—25 N·m (1.9—2.6 m-kg, 14—19 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.