Steps After Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Steps After Installation › Steps After Installation
EngineSteps After Installation
- Install the under cover.
- If the engine oil was drained, fill with the specified amount and type of engine oil.
(Refer to page D–5.) - Fill the radiator with the specified amount and type of engine coolant.
(Refer to page E–5.) - If the transmission oil was drained, fill with the specified amount and type of transmission oil.
(Refer to page J–8.) - Connect the negative battery cable.
- Start the engine and check the following.
- Engine oil, transmission oil, and engine coolant leakage.
- Ignition timing, idle speed. (Refer to page B–8.)
- Operation of emission control system.
- Perform a road test.
- Recheck the engine oil and engine coolant levels.
Parts & tools for this job For 1990 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 1990 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.