Timing belt pulley
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Timing belt pulley, Oil seal › Timing belt pulley
EngineTiming belt pulley
Timing belt pulley
Note
- If necessary, remove the pulley with a steering wheel puller (commercially available).
- Remove the timing belt pulley.
- Remove the pulley Woodruff key.
Oil seal
- Cut the oil seal lip with a razor knife.
- Remove the oil seal with a screwdriver protected with a rag.
Installation note
Oil seal
- Apply a small amount of clean engine oil to the lip of a new oil seal.
- Push the oil seal slightly in by hand.
Caution
- The oil seal must be tapped in until it is flush with the edge of the oil pump body.
- Tap the oil seal in evenly with a suitable pipe and a hammer.
Oil seal outer diameter: 44mm (1.73 in)
Timing belt pulley
- Install the timing belt pulley.
- Install the pulley Woodruff key with the tapered side toward the oil pump body.
Pulley lock bolt
- Install the pulley lock bolt.
- Tighten the pulley lock bolt using the two SST.
Tightening torque:
108—118 N·m (11.0—12.0 m·kg, 80—87 ft-lb)
Steps After Installation
- Install the under cover.
- Fill the radiator with the specified amount and type of engine coolant. (Refer to page E–5.)
- Connect the negative battery cable.
- Start the engine and check as follows:
- Engine coolant leakage.
- Ignition timing. (Refer to page B–8.)
- Recheck the engine coolant levels.
Parts & tools for this job For 1990 Mazda MX-5
- PARTTiming belt kitSearch: Mazda MX-5 1990 timing belt kit
- TOOLEngine timing tool setSearch: Mazda engine timing tool set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.