Oil pan
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Oil Pan › Oil pan
Lubrication systemOil pan
Oil pan
- Remove all foreign material from the contact surfaces.
- Apply silicone sealant to the shaded areas shown in the figure.
- Install new gaskets onto the oil pump body and the rear cover with the projections in the notches shown in the figure.
- Apply a continuous bead of silicone sealant to the oil pan along the inside of the bolt holes and overlap the ends.
- Install the oil pan.
Tightening torque:
Ⓐ: 7.8—11 N·m (80—110 cm-kg, 69—95 in-lb)
Ⓑ: 64—89 N·m (6.5—9.1 m-kg, 47—66 ft-lb)
Steps After Installation
- Install the under cover.
- Fill with the specified amount and type of engine oil. (Refer to page D–5.)
- Connect the negative battery cable.
- Start the engine and check for leaks.
- Check the oil level and add oil if necessary.
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.