Removal Note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- D Lubrication system (D) › Removal Note
Lubrication systemRemoval Note
Removal Note
Engine mount nut
- Loosen the oil pan mounting bolts.
- Remove the engine mount nuts.
- Lift the engine slightly with a hoist.
Crossmember installation bolt and nut
- Support the crossmember with a transmission jack.
- Remove the crossmember installation bolts and nuts.
Caution
- Do not damage the brake hoses, P/S hoses, and A/C hoses when lowering the crossmember.
Note
- Lower the crossmember after separating the steering intermediate shaft from the pinion shaft.
- Lower the crossmember until the clearance between the oil pan and the steering gear housing exceeds approx. 100mm (3.94 in).
Oil pan
- Remove the oil pan mounting bolts.
Caution
- Do not force a prying tool between the cylinder block and the oil pan, which may damage the contact surfaces.
- Do not damage or scratch the contact surfaces when removing the old sealant.
- Insert a screwdriver or a suitable tool only at the points shown in the figure.
- Remove the oil pan.
Oil pan baffle
Caution
- Do not bend the baffle when prying it loose.
- Insert a screwdriver or other suitable tool between the cylinder block and the baffle to separate them.
- Remove the baffle.
Installation Note
Oil pan baffle
- Remove all foreign material from the contact surfaces.
Caution
- The oil pan must be secured within 30 minutes after the sealant is applied to the baffle.
- Apply a continuous bead of silicone sealant to the baffle along the inside of the bolt holes.
- Install the baffle.
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.