Preparation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Oil Pressure › Preparation
Lubrication systemPreparation
PREPARATION
SST
INSPECTION
- Remove the oil pressure gauge sender unit.
- Screw the SST into the oil pressure gauge sender unit installation hole.
- Warm up the engine to normal operating temperature.
- Run the engine at 1,000 rpm and 3,000 rpm, and note the gauge reading.
Oil pressure:
196—294 kPa (2.0—3.0 kg/cm², 28—43 psi)—1,000 rpm
294—392 kPa (3.0—4.0 kg/cm², 43—57 psi)—3,000 rpm
- If the pressure is not as specified, check for the cause and repair. (Refer to Troubleshooting Guide.)
- Remove the SST and install the oil pressure gauge sender unit.
Tightening torque:
12—18 N·m (1.2—1.8 m·kg, 104—156 in·lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.