Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- D Lubrication system › Inspection
Lubrication systemInspection
INSPECTION
- Be sure the vehicle is on level ground.
- Warm up the engine to normal operating temperature and stop it.
- Wait for five minutes.
- Remove the oil level gauge and check the oil level and condition.
- Add or replace oil as necessary.
Note
• The distance between the L and F marks on the level gauge represents 0.8 liter (0.85 US qt, 0.70 Imp qt).
REPLACEMENT
Warning
• Be careful when draining; the oil is hot.
- Warm up the engine to normal operating temperature and stop it.
- Remove the oil filler cap and the oil pan drain plug.
- Drain the oil into a suitable container.
- Install a new gasket and the drain plug.
Tightening torque:
29—41 N·m (3.0—4.2 m·kg, 22—30 ft-lb)
- Refill the engine with the specified type and amount of engine oil.
- Refit the oil filler cap.
Oil pan capacity: 3.2 liters (3.4 US qt, 2.8 Imp qt)
- Run the engine and check for leaks.
- Check the oil level and add oil if necessary.
OIL FILTER
REPLACEMENT
- Remove the oil filter with a suitable wrench.
- Use a clean rag to wipe off the mounting surface on the engine.
- Apply a small amount of clean engine oil to the rubber seal of the new filter.
- Install the oil filter and tighten it by hand until the rubber seal contacts the base.
- Tighten the filter 1 and 1/6 turn with a filter wrench.
- Start the engine and check for leaks.
- Check the oil level and add oil if necessary.
Oil filter capacity: 0.17 liter (0.18 US qt, 0.15 Imp qt)
Parts & tools for this job For 1990 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 1990 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.