Preparation sst
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Preparation sst › Preparation sst
Cooling systemPreparation sst
PREPARATION SST
| 49 9200 145 Adapter set, radiator cap tester |
For inspection of cooling system pressure | 49 9200 146 Adapter A (Part of 49 9200 145) |
For inspection of cooling system pressure |
|---|---|---|---|
![]() |
![]() |
INSPECTION
Warning
• Never remove the radiator cap while the engine is hot.
• Wrap a thick cloth around the cap when removing it.
• When removing the radiator cap, loosen it slowly to the first stop until the pressure in the radiator is released, and then remove it.



Coolant Level (Engine cold)
- Verify that the coolant level is near the radiator filler neck.
- Verify that the coolant level in the coolant reservoir is between the FULL and LOW marks. Add coolant if necessary.
Coolant Quality
- Verify that there is no buildup of rust or scale around the radiator cap or radiator filler neck.
- Verify that coolant is free of oil.
Replace the coolant if necessary.
Coolant Leakage
- Connect a radiator tester (commercially available) and the SST to the radiator filler neck.
- Apply 103 kPa (1.05 kg/cm², 15 psi) pressure to the system.
- Verify that the pressure is held.
If not, check for coolant leakage.
Parts & tools for this job For 1990 Mazda MX-5
- FLUIDCoolantSearch: Mazda coolant antifreeze
- PARTThermostatSearch: Mazda MX-5 1990 thermostat
- TOOLCooling system pressure testerSearch: cooling system pressure tester
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.

