Removal / inspection / installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Removal / inspection / installation › Removal / inspection / installation
Cooling systemRemoval / inspection / installation
REMOVAL / INSPECTION / INSTALLATION
Caution
- Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
- Position the hose clamp in the original location on the hose, and squeeze the clamp lightly with large pliers to ensure a good fit.
- Disconnect the negative battery cable.
- Drain the engine coolant.
- Remove the under cover.
- Remove in the order shown in the figure.
- Install in the reverse order of removal.
- Radiator hose
- Coolant reservoir hose
- Cooling fan connector
- Cooling fan and additional fan
- Radiator
Inspection .............................. page E–7
INSPECTION
Check for the following and repair or replace as necessary.
- Cracks, damage, and water leakage.
- Bent fins (repair with a screwdriver).
- Distorted or bent radiator inlet.
Steps After Installation
- Install the under cover.
- Fill the radiator with the specified amount and type of engine coolant. (Refer to page E–5.)
- Connect the negative battery cable.
- Start the engine and check for leaks.
Parts & tools for this job For 1990 Mazda MX-5
- FLUIDCoolantSearch: Mazda coolant antifreeze
- PARTThermostatSearch: Mazda MX-5 1990 thermostat
- TOOLCooling system pressure testerSearch: cooling system pressure tester
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.