Control System
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Control System › Control System
Fuel and emission control systemsControl System
| Terminal | Input | Output | Connection to | Test condition | Voltage | Remark |
|---|---|---|---|---|---|---|
| 1R | ○ | Fan switch | Fan operating (Engine coolant temperature over 97°C (207°F) or diagnosis connector terminal TFA grounded) | Approx. 0V | Ignition switch ON | |
| Fan not operating (Idle) | Approx. 12V | |||||
| 1S | ○ | Blower control switch | Blower control switch at mid, high or super high position | Approx. 0V | ||
| Blower control switch OFF or low | Approx. 12V | |||||
| 1T | — | — | — | — | — | |
| 1U | ○ | Headlight switch | Headlights ON (Tail, parking, low beam/ high beam) | Approx. 12V | ||
| Headlights OFF | 0V | |||||
| 1V | ○ | Neutral or clutch switch | Neutral position or clutch pedal depressed | Approx. 0V | ||
| Other conditions | Approx. 12V | |||||
| 2A | — | — | Ground (Injector) | Constant | 0V | |
| 2B | — | — | Ground (Output) | Constant | 0V | |
| 2C | — | — | Ground (CPU) | Constant | 0V | |
| 2D | — | — | Ground (Input) | Constant | 0V | |
| 2E | ○ | Crank angle sensor (Ne-signal) | Ignition switch ON | Approx. 0V or 5V | ||
| Idle | Approx. 2V | |||||
| 2F | — | — | — | — | — | — |
| 2G | ○ | Crank angle sensor (G-signal) | Ignition switch ON | Approx. 0V or 5V | ||
| Idle | Approx. 1.5V | |||||
| 2H | ○ | Ground | California spec. | 0V | ||
| Open | Federal and Canada spec. | Approx. 2V | ||||
| 2I | ○ | Igniter | Ignition switch ON | Below 0.5V | ||
| Idle | Approx. 1V | |||||
| 2J | ○ | Ground | Constant | 0V | ||
| 2K | ○ | Airflow meter | Constant | 4.5—5.5V | ||
| 2L | ○ | Throttle sensor (Power terminal) | Accelerator pedal released | Approx. 5V | ||
| Accelerator pedal fully depressed | Approx. 0V | |||||
| 2M | — | — | — | — | — | — |
| 2N | ○ | Oxygen sensor | Ignition switch ON | 0V | ||
| Idle (Cold engine) | 0V | |||||
| Idle (After warm-up) | 0—1V | |||||
| Increase engine speed (After warm-up) | 0.5—1V | |||||
| Deceleration | 0—0.4V | |||||
| 2O | ○ | Airflow meter | Ignition switch ON | Approx. 3.8V | ||
| Idle | Approx. 3.3V | |||||
| 2P | ○ | Airflow sensor (Intake air thermosensor) | At 20°C (68°F) | Approx. 2.5V | ||
| 2Q | ○ | Water thermosensor | Engine coolant temperature 20°C (68°F) | Approx. 2.5V | ||
| After warm up | Approx. 0.4V | |||||
| 2R | — | — | — | — | — | — |
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.