Replacement
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Fuel System › Replacement
Fuel and emission control systemsReplacement
Replacement
Warning
- Before performing the following operation, release the fuel pressure from the fuel system to reduce the possibility of injury or fire. (Refer to page F–101.)
- When replacing fuel system components, keep sparks, cigarettes, and open flames away from the fuel.
- Disconnect the vacuum hose.
- Disconnect the fuel return hose.
- Remove the pressure regulator.
Tightening torque:
7.8—11 Nm (80—110 cm-kg, 69—95 in-lb)
- Use new O-ring.
- Install in the reverse order of removal.
INJECTOR
Caution
- Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
Inspection
Operation check
- Warm up the engine and run it at idle.
- Listen for operational sound of the injector with a screwdriver or a sound scope.
- If no sound is heard, measure injector resistance.
- If the injector resistance is OK, check wiring to the injector and engine control unit terminals 2A, 2U, and 2V voltages. (Refer to page F–130.)
Injector resistance
- Disconnect the injector harness.
- Measure resistance of the injector with an ohmmeter.
Resistance: 12—16Ω
- If not as specified, replace the injector.
Removal
Warning
- Before performing the following operation, release the fuel pressure from the fuel system to reduce the possibility of injury or fire. (Refer to page F–101.)
- When servicing the fuel system parts, keep sparks, cigarettes, and open flames away from the fuel.
Parts & tools for this job For 1990 Mazda MX-5
- PARTFuel filterSearch: Mazda MX-5 1990 fuel filter
- TOOLFuel pressure test kitSearch: fuel pressure test kit
- TOOLFuel line disconnect toolSearch: fuel line disconnect tool
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.