Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Pressure regulator › Inspection
Fuel and emission control systemsInspection
Caution
- Obtain the code number and deactivate the audio anti-theft system before disconnecting the battery. (Refer to page T–113.)
Inspection
Fuel line pressure
Warning
- Before performing the following operation, relase the fuel pressure from the fuel system to reduce the possibility of injury or fire. (Refer to page F–101.)
- Disconnect the negative battery terminal.
- Connect a fuel pressure gauge between the fuel main pipe and the fuel main hose. (Install clamps as shown.)
- Connect the negative battery terminal.
- Start the engine and run it at idle.
- Measure the fuel line pressure.
Fuel line pressure:
216—265 kPa (2.2—2.7 kg/cm², 31—38 psi)
Hold pressure
Perform this inspection if the fuel pressure hold inspection is not as specified. (Refer to page F–102.)
Warning
- Before performing the following operation, relase the fuel pressure from the fuel system to reduce the possibility of injury or fire. (Refer to page F–101.)
- Disconnect the negative battery terminal.
- Install a fuel pressure gauge between the fuel pipe and the fuel main hose. (Install clamps as shown.)
- Connect the negative battery terminal.
- Connect diagnosis connector terminals F/P and GND with a jumper wire.
- Turn the ignition switch ON for 10 sec. to operate the fuel pump.
- Turn the ignition switch OFF and disconnect the jumper wire.
- Block the outlet of the pressure regulator.
- Observe the fuel pressure for 5 min..
Fuel pressure:
More than 147 kPa (1.5 kg/cm², 21 psi)
- If pressure is as specified, replace the pressure regulator.
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.