Air Cleaner Element
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- F Fuel and emission control systems › Air Cleaner Element
Air Cleaner Element
Caution
• Do not clean the air cleaner element with compressed air.
Visually check the air cleaner element for excessive dirt, damage, or oil. Replace if necessary.
ADJUSTMENT
Preparation
- Check the condition of the engine (spark plugs, leaks in hoses, etc.).
- Make sure all accessories are OFF.
- Warm up the engine to normal operating temperature.
Note
• When using an externally powered timing light and/or tachometer connect it to the power connector (Blue: 1-pin).
Warning
• Do not ground the power connector terminal (Blue: 1-pin); the wiper 20A fuse will be burned.
- Connect a timing light and tachometer to the diagnosis connector terminal IG–.
Ignition Timing
Caution
• Be extremely careful when making connections to the diagnosis connector as a mistaken connection will cause a malfunction.
- Connect the SST and set the TEST SW to “SELF TEST” or connect diagnosis connector terminals TEN and GND with a jumper wire.
- Check the idle speed, and set it to specification if necessary. (Refer to page F–76.)
Idle speed: 850 ± 50 rpm
- Verify that the timing mark (Yellow) on the crankshaft pulley and the timing belt cover are aligned.
Ignition timing: 10° ± 1° BTDC (at idle)
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.