Preparation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Preparation › Preparation
Fuel and emission control systemsPreparation
PREPARATION
SST
For inspection of ignition timing and idle speed.
05U0FX-052
BASIC INSPECTION
Engine Oil
- Be sure the vehicle is on level ground.
- Warm up the engine to normal operating temperature and stop it.
- Wait for five minutes.
- Remove the oil level gauge and check the oil level and condition.
- Add or replace oil if necessary.
Note
- The distance between the L and F marks on the level gauge represents 0.8 liter (0.85 US qt, 0.70 Imp qt).
05U0FX-053
Coolant Level (Cold engine)
Warning
- Never remove the radiator cap while the radiator and engine are hot.
- Wrap a thick cloth around the cap while carefully removing it.
05U0FX-054
- Verify that the coolant level is at the bottom of the radiator filler neck.
- Verify that the level in the coolant reservoir is between the FULL and LOW marks. Add coolant if necessary.
Battery
05U0FX-055
- Check for loose or corroded terminals and connections.
- Clean and tighten the connections as necessary.
- Measure the battery voltage. If the voltage is 12.6V or less, recharge the battery. (Refer to Section G.)
05U0FX-056
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.