Inspection
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- F Fuel and emission control systems › Inspection
Fuel and emission control systemsInspection
Inspection
- Cool the air valve to 0°C (31°F).
- Mark the shaft.
- Warm the air valve with a hot air gun and verify that the shaft moves in the direction of arrow.
- Replace the air valve if necessary.
Installation
Note
• Install a new gasket.
Install in the reverse order of removal.
Tightening torque:
4.9—7.8 N·m (50—80 cm-kg, 43—69 in-lb)
ISC VALVE
Inspection
- Disconnect the ISC valve connector.
- Connect an ohmmeter between the terminals of the ISC valve and measure the resistance.
Resistance (at 20°C [68°F]): 12 ± 1Ω
- If not as specified, replace the ISC valve.
Replacement
- Disconnect the ISC valve connector.
- Remove the air pipe.
Note
• Before disconnecting the water hose, drain the engine coolant.
- Disconnect the water hose and the air hose.
- Remove the ISC valve.
Note
• Install a new gasket.
- Install in the reverse order of removal.
Tightening torque:
2.8—4.0 N·m (29—41 cm-kg, 25—35 in-lb)
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.