System operation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Preparation sst › System operation
Fuel and emission control systemsSystem operation
49 B019 9A0
System Selector
For inspection of air valve
SYSTEM OPERATION
Air Valve
—Perform this inspection when the engine is cold. (Engine coolant temperature below 20°C [68°F].)
Note
- When using an externally powered tachometer connect it to the power connector (Blue: 1-pin).
Warning
- Do not ground the power connector terminal (Blue: 1-pin); the wiper 20A fuse will be burned.
- Connect a tachometer to the diagnosis connector terminal IG−.
- Connect the SST and set the TEST SW to "SELF TEST" or connect diagnosis connector terminals TEN and GND with a jumper wire.
- Verify that the engine speed gradually decreases as the engine warms up.
- Remove the SST or the jumper wire.
ISC Valve
- Warm up the engine to the normal operating temperautre and run it at idle.
- Disconnect the ISC valve connector (Black: 2-pin) and verify that the valve clicks and the engine speed increases to approx. 1,200 rpm.
- Reconnect the ISC valve connector.
AIR VALVE
Removal
Note
- Before disconnecting the water hoses, drain the engine coolant.
- Disconnect the water hoses.
- Remove the air valve from the intake manifold.
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.