Outline (page 3 of 3)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Outline
Fuel and emission control systemsOutline · page 3 of 3
| Component | Function | Remark |
|---|---|---|
| Air cleaner | Filters air entering throttle body | |
| Airflow meter | Detects amount of intake air; sends signal to engine control unit | ● Intake air thermosensor and fuel pump switch included ● Use Vref (5 volt) as power source |
| Air valve | When cold, supplies bypass air into dynamic chamber | ● Engine speed increased to shorten warm-up period ● Thermowax type |
| Atmospheric pressure sensor | Detects atmospheric pressure; sends signal to engine control unit | Built-in ECU |
| Catalytic converter | Reduces HC, CO, and NOx by chemical reaction | Monolith type |
| Charcoal canister | Stores gas tank fumes while engine stopped | |
| Circuit opening relay | Voltage for fuel pump while engine running | |
| Clutch switch (M/T) | Detects in-gear condition; sends signal to engine control unit | Switch OFF when clutch pedal released |
| Diagnosis connector | Concentrated service connector Concentrated terminals are: 1. EGI self-diagnosis terminal 2. Initial set terminal 3. Fuel pump check terminal 4. Cooling fan check terminal |
21-pin (Black) |
| Crank angle sensor G-signal Ne-signal |
Detects No.1 cylinder TDC; sends signal to engine control unit Detects crank angle at 180° intervals; sends signal to control unit |
|
| Dynamic chamber | Interconnects all cylinders | |
| Engine control unit (ECU) | Detects the following: 1. A/C operation 2. Air/fuel ratio (Oxygen concentration) 3. Atmospheric pressure 4. Braking signal 5. Cranking signal 6. E/L operation . 7. Engine coolant temperature 8. Engine speed 9. In-gear condition 10. Intake air amount 11. Intake air temperature 12. No.1 piston TDC 13. P/S operation 14. Initial set signal 15. Throttle valve fully closed 16. Throttle valve opening amount |
1. A/C switch 2. Oxygen sensor 3. Atmospheric pressure sensor 4. Stoplight switch 5. Ignition switch (START position) 6. Cooling fan relay Light and turn relay Blower motor switch 7. Water thermosensor 8. Crank angle sensor (Ne-signal) 9. Neutral and clutch switches 10. Airflow meter 11. Intake air thermosensor 12. Crank angle sensor (G-signal) 13. P/S pressure switch 14. Diagnosis connector 15. Throttle sensor (IDL signal) 16. Throttle sensor (POW signal) |
| Controls operation of the following: 1. A/C (Cut off) 2. Fail-safe function 3. Fuel injection system 4. Idle speed control 5. Ignition timing control system 6. Monitor function 7. Purge control system |
1. A/C relay 2. Self-diagnosis checker and MIL 3. Injector 4. ISC valve 5. Igniter 6. Monitor lamp (Self-diagnosis checker) 7. Solenoid valve (Purge control) |
Parts & tools for this job For 1990 Mazda MX-5
- PARTExhaust gasketSearch: Mazda MX-5 1990 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.